Thursday, March 12, 2009

Rev counter bracket

Rev counter bracketSo I've finally got around to making up a bracket to hold the sensor for the rev counter.

I opted to mount it up against the cam shaft, which will hold the magnet, as it's much more accessible there than on the main shaft.

Also things down towards the main shaft are considerably more dirty, and therefore potentially more troublesome for the electronics, in comparison to where it is now.

It's temporarily held in by the oversize self tapping screws you can see, because I didn't have any of the right size set screws on board.

There was just not enough time to run up the main engine to test it all - Soon though....

No comments:

Post a Comment